Page 1 of 1
Cleaned Lens/Adjusted Little Wheel/Now PS2 will not Power On
Posted: Sun Nov 07, 2004 11:49 pm
by tylercwhite
So I carefully took apart my PS2 and cleaned the lens and slightly adjusted the disc tray gear. However, then when I tried to turn it on - it would not turn on. Nothing at all. Any suggestions?
Posted: Sat Nov 13, 2004 12:17 pm
by Crissy
Not in a bad way, but i think you broke it. :shock:
Posted: Thu Dec 09, 2004 6:56 pm
by Captain_Sassy
I did the same thing as you, i cleaned my lense but i disconnected the silver tape that goes from the top half to the bottom and i don't know where it goes back. This might be your problem
Posted: Tue Jan 18, 2005 3:31 am
by Bubs
I also had the same thing happen to me so I reopened the ps2 and saw that the little silver ribbon had become disconnected. I took off the whole cover top and bottom by the way and as I looked underneath I saw a the little slot that the ribbon came out of. After I shoved the ribbon back into the slot It powered up no problem.
Posted: Tue Nov 14, 2006 3:49 am
by khat17
Could also be that the ribbon-cable is connected the wrong way (upside-down). If that is the case, you wouldn't get any standy red light when you power on the switch at the back. Check that and post your results. Hope the info provided by everyone was helpful.
PeAcE.