| View previous topic :: View next topic |
| Author |
Message |
tylercwhite
Joined: 07 Nov 2004
Posts: 1
|
 Posted: Sun Nov 07, 2004 11:49 pm Post subject: Cleaned Lens/Adjusted Little Wheel/Now PS2 will not Power On |
 |
|
| So I carefully took apart my PS2 and cleaned the lens and slightly adjusted the disc tray gear. However, then when I tried to turn it on - it would not turn on. Nothing at all. Any suggestions? |
|
| Back to top |
|
 |
Crissy
Joined: 11 Nov 2004
Posts: 3
|
| Posted: Sat Nov 13, 2004 12:17 pm Post subject: |
|
|
| Not in a bad way, but i think you broke it. :shock: |
|
| Back to top |
|
|
Captain_Sassy
Joined: 09 Dec 2004
Posts: 1
|
| Posted: Thu Dec 09, 2004 6:56 pm Post subject: |
|
|
| I did the same thing as you, i cleaned my lense but i disconnected the silver tape that goes from the top half to the bottom and i don't know where it goes back. This might be your problem |
|
| Back to top |
|
|
Bubs
Joined: 18 Jan 2005
Posts: 1
Location: utah
|
| Posted: Tue Jan 18, 2005 3:31 am Post subject: |
|
|
| I also had the same thing happen to me so I reopened the ps2 and saw that the little silver ribbon had become disconnected. I took off the whole cover top and bottom by the way and as I looked underneath I saw a the little slot that the ribbon came out of. After I shoved the ribbon back into the slot It powered up no problem. |
|
| Back to top |
|
|
khat17
Joined: 11 Nov 2006
Posts: 79
|
| Posted: Tue Nov 14, 2006 3:49 am Post subject: |
|
|
Could also be that the ribbon-cable is connected the wrong way (upside-down). If that is the case, you wouldn't get any standy red light when you power on the switch at the back. Check that and post your results. Hope the info provided by everyone was helpful.
PeAcE. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
